The small green box on its left merges the left and right channels to forward it to the subwoofer section, which is the complete left half of this diagram (except the red box on the left, which is just power). In the middle yellow box there's some trebble/volume/bass control. The sound comes in on the right, in the green box. The block I want to short-circuit is the pink one on the left. My question is: should I disconnect the input and output from the compressor (in that case should I remove power supply as well, which would be very annoying), or can I leave it connected but short-circuited? I will connect the input to the output so it gets forwarded to the next stage. Its active components are a JFET and four op-amps. I have an Altec Lansing ATP3 2.1 audio system PCB which I reverse-engineered, and I would like to bypass the JFET compressor that's on it.
0 Comments
Leave a Reply. |